Remove wheels from vehicle. Inspect brakes. Computer spin balance. Reinstall wheels to vehicle and torque lug nuts to manufacturer's specifications. Includes rotation. *****************
TODD M. gave our service a 5 star review on 7/22/2021
TEST SYSTEM PRESSURES PERFORM VISUAL INSPECTION OF COMPRESSOR DRIVE BELT & CONDENSOR COMPARE DUCT TO OUTSIDE TEMPERATURE DIFFERENCE * AFTER INSP SYSTEM FOR LEAKS WE FOUND THAT THE LINES AT EXPANSION VALVE ARE WET WITH REFRIG OIL/ DIRT. * LINE WILL HAVE TO BE RESEALED BEFORE SYSTEM CAN BE RECHARGED. * RECOMMEND BRINGING VEH BACK TO DEALER FOR REPAIRS. ****************
HANNAH L. gave our service a 5 star review on 5/26/2021
CLEAN WHEEL AND TIRE BEADS. APPLY SEALER AS REQUIRED – Includes dismount tire & wire wheel rim INSTALL NEW VALVE STEM *****************
Drain & fill oil, Install new oil filter. Lubricate chassis, latches & hinges. Inspect fluid levels (when access time permits) Set tire pressure to specs. ******************
Drain cooling system for pick-up. Flush & refill with 50/50 mix of 5 year coolant & water. Inspect belts & hoses. Inspect thermostat & fan operation.
DTC P0442 SMALL EVAPORATIVE EMISSION SYSTEM LEAK DETECTED DTC P0456 VERY SMALL EVAPORATIVE EMISSION SYSTEM LEAK DETECTED . PERFORM VISUAL INSPECTION OF EVAPORATIVE EMISSION SYSTEM LINES AND CONNECTIONS . NO OBVIOUS PROBLEMS COULD BE SEEN THE SYSTEM WILL HAVE TO BE SMOKE TESTED .
INSTALL DRIVERS SIDE LOW BEAM BULB .
INSTALL FRONT LICENSE PLATE .
MAINTENANCE INSPECTION – **************
Remove and reinstall four wheels to inspect brake condition. Inspect entire system for leaks. Lining remaining is: Front ( 60 %) Rear ( 25 %) *****************
REMOVE AND REPLACE CABIN AIR FILTER
REMOVE AND REPLACE EVAPORATIVE EMISSION SYSTEM CANISTER ,CLEAR CODES AND TEST DRIVE VEHICLE .
REMOVE AND REPLACE FLEX PIPE
REMOVE AND REPLACE SPARK PLUGS
THE EVAPORATIVE EMISSION SYSTEM CANISTER IS LEAKING .
************************
Hazmat disposal ***************
LINDA Y. gave our service a 5 star review on 2/25/2021
Drain & fill oil, Install new oil filter. Lubricate chassis, latches & hinges. Inspect fluid levels (when access time permits) Set tire pressure to specs. ******************
REMOVE FILTER FOR INSP. FILTER PLUGGED WITH POLLEN AND DEBRIS. VACUUM HOUSING AS NECC, INSTALL NEW FILTER. **********************************
Remove wheels from vehicle. Inspect brakes. Computer spin balance. Reinstall wheels to vehicle and torque lug nuts to manufacturer's specifications. Includes rotation. *****************
Road test vehicle. Check all suspension and steering parts for wear. Check tire pressure and condition. Check riding height. Check alignment of all four wheels. Adjust caster, camber, toe-in, Center steering wheel. Perform steering angle relearn as required. ******************** Factory adjustments are not always provided. Additional parts and labor may be required. ********************
************************
TODD [ BLAKE ] M. gave our service a 5 star review on 4/7/2020